Everything about car waxing and waxing

Car waxing or waxing

Car buffing or painting is a common method for repairing surface scratches and minor discoloration on a car’s body. This method is very popular because it is less expensive than a full paint job and is quick to perform. Below are the important points and steps of this process:

What is licking?

Scraping involves using a plastic or metal tool (scraper) to fill in scratches and dents on a car’s body with a special paint. This method is used for deeper scratches and areas where the paint has peeled off.

What is penmanship?

Brushing means using a special paint pen to repair thin, superficial lines and scratches. This method is best for small, minor lines and requires a high level of precision.

Steps for lapping or scraping a car:

  1. Cleaning the damaged surface
  • First, the scratched area must be thoroughly cleaned and dried. It is recommended to use a car detergent to remove grease and dirt.
  1. Choosing the right color
  • The car’s color must match the exact body color code (the code is usually specified in the car’s manual or on a sticker inside the car).
  1. Tool preparation
  • The tools needed include a plastic or metal squeegee, paint pen, car paint, and clear spray.
  1. Filling in lines and scratches
  • To lick, place some color on the root and gently rub over the line or scratch to fill it.
  • To brush, carefully move the tip of the brush along the line and apply the color evenly.
  1. Drying and color fixation
  • Let the paint dry completely (about 24 hours). Then use clear spray to seal and shine the surface.
  1. Final polishing
  • Once completely dry, polish the surface with a soft polish until smooth and shiny.

Does lapping and brushing a car cause the car to become two-tone?

Car waxing and waxing can cause discoloration if not done properly, but this problem can be prevented by following a few important tips. Let’s examine this issue:

Causes of two-tone car paint after lapping or scraping

  1. Inaccurate Color Match
    If the paint used for the repair is not the same as the vehicle’s color code or the paint quality is poor, there may be a color difference between the repair area and other parts of the body.
  2. Differences in paint application methods
    The factory paint application method is different from brushing or lapping. The factory uses advanced techniques such as uniform spraying of paint, while brushing is done by hand and may create a difference in appearance.
  3. Not using clear coat
    The clear coat applied at the end of painting a car makes the paint shiny and uniform. If clear coat is not used after brushing, the repaired surface will appear duller or shinier.
  4. Light and Viewing Angle
    In different lights or from certain angles, the restored color may look slightly different. This is due to differences in the color structure used.
  5. Original Car Paint Fading
    If the original car paint has dulled or discolored over time, the new paint may look brighter, even if it matches the paint code.

How to prevent the car from becoming two-tone?

  1. Use paint that matches the car’s paint code
  2. Final Polishing
    After the paint dries, polishing the repaired surface can help even out the paint.
  3. Using Clear (Transparent Layer)
    After brushing or lapping, using a clear spray is essential to make the surface shiny and smooth.
  4. Consult a professional
    If you do not have enough experience, it is better to leave the repair to the professionals so that the work is done with high precision.
  5. Test the color before applying
    Before using, test the color on a small surface or inconspicuous area to ensure compatibility.

Conclusion:

If the lapping or brushing is done carefully and with the proper technique, it is possible to prevent the car from becoming discolored. However, for larger repairs or deep scratches, it is better to use more professional methods.

Share